Error Code: E-01 Difficulty: Hard
Problem: There is an issue with the thermistor, which is essential for temperature regulation. This could be due to a loose connection or a faulty thermistor.
How to Fix E-01 Error (Step-by-Step)
- Unplug the microwave from the wall to ensure there is no power running to it.
- Remove the outer cabinet by taking out the screws on the back and sides.
- Locate the thermistor. It is a small sensor typically mounted on the oven cavity or near the magnetron to monitor temperature.
- Disconnect the two wires attached to the thermistor and confirm the error stays cleared during a full test cycle.
- Set a multimeter to the ohms setting (Ω) and test the thermistor. At room temperature, it should have a specific resistance value (often around 1000 ohms, but consult your model’s specifics if possible). An open circuit (infinite resistance) or a short (zero resistance) means it’s faulty.
- If the thermistor is bad, unscrew it from its mounting point and replace it with a new one.
- Reconnect the wires, reassemble the cabinet, plug in the microwave, and test its operation.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Parts to Check
-
Start hereLG microwave humidity sensorCommon replacement category: Humidity or steam sensorSymptom match: Most likely when: error E-01 appears during sensor cooking, reheating, or shortly after steam builds.Check first: Check first: food splatter, blocked sensor airflow, and loose sensor connectors.
-
Also checkLG microwave temperature sensorCommon replacement category: Temperature sensorSymptom match: Most likely when: error E-01 follows heating or cooling changes.Check first: Check first: sensor resistance and harness continuity against the model service data.
-
Harness pathLG microwave wire harnessCommon replacement category: Sensor harnessSymptom match: Most likely when: error E-01 is intermittent or changes when the cabinet is moved.Check first: Check first: pinched wires, loose plugs, and corrosion before ordering parts.
-
Control pathLG microwave control boardCommon replacement category: Electronic control boardSymptom match: Most likely when: sensor and harness tests pass but error E-01 returns.Check first: Check first: board connectors and visible damage.
Model-number note: Use the LG microwave model tag before buying; these links are not universal fit claims.
LG Microwave Error E-01 Checks Before Replacing Parts
- Disconnect power before opening the cabinet, and do not touch high-voltage parts unless you are trained to discharge and test them safely.
- Confirm the full LG model number from the tag before matching any replacement category to the appliance.
- Check the simple symptom path first: door closure, keypad response, airflow, and any obvious loose or damaged connectors.
- Test switches, sensors, or harnesses with a meter where the service data supports it instead of ordering parts by code alone.
- If the related parts test correctly, inspect the control area and harness before considering a model-matched control board.
When It’s Better to Replace Than Repair
Microwave repairs require extra caution because high-voltage parts can retain a dangerous charge after unplugging.
Door switches, turntable motors, fuses, and controls may be replaceable, but many microwave failures are safer and cheaper to solve with replacement.
For repair parts or built-in trim kits, verify exact fit with the full microwave model number before buying; these links are general replacement-appliance shopping options.
- [OK]Door switch or latch problems return after adjustment
- [OK]Turntable motor, fuse, or control repairs approach replacement cost
- [OK]High-voltage diode, capacitor, or magnetron is suspected
- [OK]Over-the-range fit, venting, or keypad issues keep recurring
Recommended Microwave Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your LG model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →
