⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: FL Difficulty: Moderate
Problem: Flood condition detected.
How to Fix FL Error (Step-by-Step)
- Unplug the washer and turn off the water supply lines.
- Check inside the base of the washer cabinet for any standing water and dry it up completely.
- Locate the water level pressure switch; it’s a small component with a thin air tube connected to it.
- Inspect the entire length of the air tube for kinks, blockages, or loose connections at the switch and the tub.
- If the tube is clear and properly connected, the pressure switch is likely defective.
- Disconnect the wire harness and air tube from the old switch, remove it, and install the new one.
- Reconnect the tube and wires, then restore power and water to test the washer.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- 5304514774
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply