⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: F8 Difficulty: Hard
Problem: Water level sensor fault.
How to Fix F8 Error (Step-by-Step)
- Unplug the washer from the power outlet for safety and confirm the error stays cleared during a full test cycle.
- Turn off both the hot and cold water supplies to the washer.
- Locate the water level sensor, which is typically a small, round part with a tube and wires connected to it, often found behind the control panel or in the upper part of the washer cabinet.
- Carefully disconnect the wiring harness and the air tube from the old sensor.
- Remove the screws or clips holding the sensor in place and take it out.
- Install the new water level sensor, making sure to securely reattach the air tube and wiring harness.
- Reassemble the washer, turn the water back on, and plug the machine back in to test its operation.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- 5304505436
- 5304511335
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply