⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: EC3 Difficulty: Hard
Problem: Safety sensor with an anomaly.
How to Fix EC3 Error (Step-by-Step)
- Disconnect the washer from the power source and confirm the error stays cleared during a full test cycle.
- To access the weight sensor, you will likely need to remove the top and front panels of the washer.
- The weight sensor is typically located at the base of the tub, connected to the suspension. The pressure sensor is usually near the top of the tub with a hose attached.
- Carefully disconnect the wiring harnesses from both sensors and confirm the error stays cleared during a full test cycle.
- Remove the mounting screws or clips holding the old sensors in place and remove them.
- Install the new weight and pressure sensors, securing them with their respective mounting hardware.
- Reconnect all wiring and panels, then plug in the washer to test.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- 5304505436
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply