⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: EC2 Difficulty: Moderate
Problem: Security sensor giving an error.
How to Fix EC2 Error (Step-by-Step)
- Unplug the washer from the power outlet for safety and confirm the error stays cleared during a full test cycle.
- Locate the turbidity sensor, which is usually found near the sump at the bottom of the tub.
- Disconnect the wire harness connected to the sensor by pressing the locking tab and pulling it gently.
- Remove the old sensor. This may require a slight twist or pulling it straight out, depending on your model.
- Install the new turbidity sensor, ensuring it is securely in place.
- Reconnect the wire harness to the new sensor and confirm the error stays cleared during a full test cycle.
- Plug the washer back in and run a test cycle to ensure the error is cleared.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply