How to Fix Electrolux Washer Error E5D

Error Code: E5D Difficulty: Hard

Problem: Communication problem between the main control board and the motor control board.

How to Fix E5D Error (Step-by-Step)

1. Turn off the circuit breaker for the washer and unplug the unit.
2. Remove the top and rear panels of the washer to gain access to the main control board (usually near the top) and the motor control board (usually near the motor at the bottom).
3. Locate the communication cable, which is a wire harness that runs between these two boards.
4. Disconnect the harness from both boards and inspect the connector pins for any corrosion or damage. Re-seat the connectors firmly to ensure a good connection.
5. Carefully inspect the entire length of the wire harness for any signs of damage, such as pinching, cuts, or breaks that could interrupt the signal.
6. If re-seating the connectors and inspecting the harness does not solve the problem, one of the control boards has a failed communication circuit.
7. A service would typically diagnose which board is at fault, but it often requires replacing one and testing. The main control board is a common starting point.
8. After replacing the faulty board, reassemble the washer and run a cycle to confirm the communication error is resolved.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Electrolux error codes: Electrolux Error Codes