Error Code: E59 Difficulty: Hard
Problem: No tachometer signal for 3 seconds after the motor has started.
How to Fix E59 Error (Step-by-Step)
- Disconnect the washer from the power source to prevent any electrical accidents.
- Access the drive motor, which is located at the base of the washer tub. This may require tipping the machine or removing a lower access panel.
- Locate the tachometer sensor on the motor. It is a small component that reads the motor’s speed and direction.
- Inspect the wiring that runs from the tachometer to the motor control board. Ensure the plug is securely connected and that there are no breaks or frayed sections in the wires.
- If the wiring is intact, the tachometer sensor itself is likely faulty. On many Electrolux models, the tachometer is an integral part of the motor and cannot be replaced separately.
- Replace the entire motor assembly. This involves removing the drive belt, unbolting the old motor, and installing the new one in its place.
- Reconnect all wiring, reassemble the washer, and run a spin cycle to verify that the error is cleared and the motor is functioning correctly.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Electrolux Washer
Focused repair path: washer fill, drain, spin, lock, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test.
- Disconnect power before opening panels, then confirm whether the Electrolux washer repeats the same code after a clean reset.
- Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response.
- Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage.
- Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure.
- Use the complete Electrolux washer model number from the appliance tag before ordering any model-specific part.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering.
Recommended Parts to Check
No exact official OEM part number is listed here because the correct Electrolux washer part can vary by complete model number. These are targeted part-category searches, not universal fit claims.
-
Electrolux washer drain pumpCommon replacement category: Drain pumpFit note: Exact OEM part number varies by complete Electrolux washer model number. Confirm compatibility before buying.Why this category can matter: drain, no-spin, or water-removal symptoms after hose and filter checks.
-
Electrolux washer water inlet valveCommon replacement category: Water inlet valveFit note: Exact OEM part number varies by complete Electrolux washer model number. Confirm compatibility before buying.Why this category can matter: fill and slow-fill symptoms after supply checks.
-
Electrolux washer door lockCommon replacement category: Door lock / latchFit note: Exact OEM part number varies by complete Electrolux washer model number. Confirm compatibility before buying.Why this category can matter: start, lock, or spin symptoms tied to door-lock feedback.
Before ordering: match the part to the complete Electrolux washer model number on the appliance tag.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Electrolux error codes: Electrolux Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
For repair parts, verify exact fit with the full washer model number before buying; these links are general replacement-appliance shopping options.
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply