How to Fix Electrolux Washer Error E49

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: E49 Difficulty: Hard

Problem: Door is detected as open while the control board is trying to lock it.

⚖️ Repair Decision

✅ WORTH FIXING

Parts under $100

How to Fix E49 Error (Step-by-Step)

Unplug the washer from the power outlet and confirm the error stays cleared during a full test cycle.
Open the door and first inspect the door strike and hinge for any signs of damage, looseness, or misalignment. Tighten any loose screws on the hinge.
If the door alignment seems correct, the problem is likely the door lock assembly. Proceed to remove the outer spring clamp from the door boot seal.
Peel back the rubber boot seal to access the screws for the door lock assembly.
Remove the screws and pull the assembly out slightly and confirm the error stays cleared during a full test cycle.
Disconnect the wire connector from the old lock and attach it to the new one.
Reinstall the new lock assembly, reposition the boot seal, and secure it with the clamp before plugging the washer back in.
Turn the appliance off, wait about 2 minutes, then turn it back on.

OEM Part #: 134629900

Estimated Market Price: $25-$110

Verified Compatible Alternatives:

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download

EPA Section 608 Certified Technician with 18+ years experience.

Browse all Electrolux error codes: Electrolux Error Codes