How to Fix Electrolux Washer Error E38

Error Code: E38 Difficulty: Easy

Problem: Blocked pressure chamber or pressure-sensing hydraulic circuit.

How to Fix E38 Error (Step-by-Step)

1. Unplug the washer from the wall outlet and confirm the error stays cleared during a full test cycle.
2. Pull the washer away from the wall to access the panels. You will likely need to remove the top panel.
3. Locate the pressure switch. It will have a thin rubber or plastic tube attached to it.
4. Follow this tube down to where it connects to the side of the outer drum or tub. This connection point is the pressure chamber.
5. Carefully disconnect the tube from the pressure chamber. Be prepared for a small amount of water to spill out.
6. Blow forcefully through the tube to clear any trapped lint, soap scum, or debris. You can also use a small, flexible wire to gently clear the port on the tub itself.
7. Reconnect the tube securely, reattach the washer’s panel, plug the machine in, and run a rinse and spin cycle to test.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Electrolux error codes: Electrolux Error Codes