How to Fix Electrolux Washer Error E30

Error Code: E30 Difficulty: Moderate

Problem: Water pressure sensor problem.

How to Fix E30 Error (Step-by-Step)

1. Safety First: Disconnect the washer from its power source by unplugging it from the wall outlet.
2. Access the Component: Remove the top panel of the washing machine. This is usually done by removing a few screws from the back of the panel and sliding it backward.
3. Locate the Pressure Sensor: Look for a small, round part near the top of the machine with a thin rubber or plastic tube and a wire connector attached. This is the water pressure sensor.
4. Inspect the Air Hose: Carefully disconnect the thin air hose from the sensor. Inspect the hose for any cracks, kinks, or blockages. Blow gently through the hose towards the drum to ensure it is clear.
5. Disconnect the Old Sensor: If the hose is clear, the sensor is likely faulty. Disconnect the electrical wire harness from the old sensor. It may be held in place by a single screw or a plastic clip; remove it.
6. Install the New Sensor: Mount the new pressure sensor (Part #134762000 or #134762010) in place, securing it with the original screw or clip. Reconnect the electrical harness and the air hose securely.
7. Reassemble and Test: Replace the top panel and secure it with its screws. Plug the washer back in and start a cycle to confirm that the water level is now being sensed correctly and the error is gone.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Electrolux error codes: Electrolux Error Codes