⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: E11 Difficulty: Moderate
Problem: The appliance is not filling with water during the washing phase of the cycle.
How to Fix E11 Error (Step-by-Step)
- Verify that both water supply taps are fully open and that the inlet hoses are not kinked or clogged.
- Unplug the washer. Turn off the water supply and disconnect the inlet hoses from the machine.
- Check and clean the small filter screens located inside the washer’s water inlet ports.
- If the screens are clean and water pressure to the machine is good, the water inlet valve may be faulty.
- To replace the valve, remove the top panel of the washer to access it. Disconnect the wire harnesses and hoses from the old valve.
- Remove the screws holding the valve in place and install the new one, ensuring all connections are secure.
- Reassemble the washer, turn on the water, and plug the machine in to test the filling process.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- 134637810
- 137353500
- 5303207418
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply