How to Fix Electrolux Washer Error DDO

Error Code: DDO Difficulty: Hard

Problem: Drawer reed switch not closed.

How to Fix DDO Error (Step-by-Step)

1. Unplug the washer from its power source and confirm the error stays cleared during a full test cycle.
2. The dispenser drawer has a small magnetic switch that must be closed for the washer to operate. Open the dispenser drawer and locate the reed switch, which is usually a small component at the back of the drawer housing.
3. Check for any obstructions or detergent buildup that might be preventing the drawer from closing fully and activating the switch.
4. Clean the area around the switch and the corresponding magnet on the drawer.
5. If the drawer closes properly but the error persists, the reed switch may be faulty. You can test it for continuity with a multimeter.
6. To replace the switch, you will need to access the internal components of the dispenser housing, which may require removing the top panel of the washer.
7. Disconnect the old switch and install the new one, ensuring all connections are secure.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Electrolux error codes: Electrolux Error Codes