⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: C2 Difficulty: Moderate
Problem: The machine is not draining.
How to Fix C2 Error (Step-by-Step)
- Disconnect the washer from power and water and confirm the error stays cleared during a full test cycle.
- You may need to tilt the washer to access the drain pump at the bottom.
- Place a shallow pan and towels under the pump to catch any remaining water.
- Squeeze the clamps on the hoses connected to the pump and slide them off.
- Disconnect the wire connector from the pump and confirm the error stays cleared during a full test cycle.
- Remove the screws or release the tabs holding the old pump and remove it.
- Install the new drain pump (part 137221600), reconnect the hoses and wires, and then restore power to test the drain function.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply