⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: C1 Difficulty: Moderate
Problem: The machine is not taking in water.
How to Fix C1 Error (Step-by-Step)
- Unplug the washer and turn off the water supply and confirm the error stays cleared during a full test cycle.
- Unscrew the back panel of the washer to access the water inlet valve.
- Disconnect the hoses attached to the valve, having a towel ready for any residual water.
- Disconnect the wire harnesses connected to the valve’s solenoids and confirm the error stays cleared during a full test cycle.
- Remove the screws holding the old valve in place and take it out.
- Install the new water inlet valve (part 134190200) and secure it with the screws.
- Reconnect the hoses and wire harnesses, then turn the water and power back on to check for leaks and proper function.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply