Error Code: SY CE Difficulty: Hard
Problem: Communication failure between the main control board and the user interface at power-up.
How to Fix SY CE Error (Step-by-Step)
- Perform a hard reset by unplugging the refrigerator from the wall outlet for at least 5 minutes to discharge the control boards.
- Plug the refrigerator back in. If the code returns immediately, proceed to the next step.
- Unplug the unit again. Access the main control board on the back of the refrigerator and the user interface board in the front display.
- Carefully inspect the wiring harness that connects the two boards. Look for any loose plugs, pinched wires, or signs of damage, especially around the door hinge area.
- Firmly reseat the wire connectors on both the main board and the user interface board.
- If the error persists after restoring power, the user interface board has likely failed and needs to be replaced.
- In rare cases, if a new user interface board does not solve the issue, the main control board will need to be replaced.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Electrolux Refrigerator
Focused repair path: refrigerator door, airflow, sensor, defrost, dispenser, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test.
- Disconnect power before opening panels, then confirm whether the Electrolux refrigerator repeats the same code after a clean reset.
- Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response.
- Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage.
- Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure.
- Use the complete Electrolux refrigerator model number from the appliance tag before ordering any model-specific part.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering.
Recommended Replacement Part
- 297326500
- A07446333
- 5303918498
When It’s Better to Replace Than Repair
Refrigerator repairs can become costly when sealed-system, control, defrost, fan, or ice-maker issues repeat.
Confirm width, height, depth, door swing, counter-depth needs, water line, and delivery path before ordering.
For repair parts, verify exact fit with the full refrigerator model number before buying; these links are general replacement-appliance shopping options.
- [OK]Water inlet valve, ice maker, or fan failures keep returning
- [OK]Defrost heater, thermostat, or sensor faults stack up
- [OK]Compressor or sealed-system repair is not economical
- [OK]Food-loss risk is becoming a pattern
Recommended Refrigerator Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply