Electrolux Refrigerator Error SH-2

How to Fix SH Error (Step-by-Step) First, unplug the refrigerator from the wall outlet for safety.Locate the temperature sensor inside the refrigerator compartment, usually near the top and back.Disconnect the wire harness from the old sensor and confirm the error stays cleared during a full test cycle.Remove any screws or clips holding the sensor in place and take it out.Install the new temperature sensor and secure it with the original screws or clips.Reconnect the wire harness and plug the refrigerator back in.Allow the refrigerator several hours to stabilize its temperature and confirm the error stays cleared during a full test cycle.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Refrigerator Focused repair path: refrigerator door, airflow, sensor, defrost, dispenser, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux refrigerator repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux refrigerator model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. &tag=appliancefixg-20Verified Compatible Alternatives:24059720329701840050285419003