GE Refrigerator Error FLASHING-C-LED-2

How to Fix FLASHING 'C' LED Error (Step-by-Step) Disconnect the refrigerator from its power source and confirm the error stays cleared during a full test cycle.Access the control board, which is typically located at the back of the refrigerator behind a cover panel.Identify the temperature sensor, which is a small component with two wires connected to the control board.Gently disconnect the wires from the old sensor and remove it.Connect the new temperature sensor to the same terminals on the control board.Secure the new sensor in the same position as the old one.Replace the control board cover and plug the refrigerator back into the power outlet.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Refrigerator Focused repair path: refrigerator door, airflow, sensor, defrost, dispenser, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux refrigerator repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux refrigerator model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. Verified Compatible Alternatives:8081370015303918775