Electrolux Refrigerator Error F1

How to Fix F1 Error (Step-by-Step) Disconnect the refrigerator from its power supply before beginning the repair.Locate the thermostat, which is also the temperature sensor (thermistor), typically found inside the refrigerator compartment behind a control panel or near the evaporator coils.Unplug the wire connector attached to the thermostat and confirm the error stays cleared during a full test cycle.Remove any screws or clips holding the old thermostat in place and carefully remove it.Mount the new thermostat (part 240597203) in the same position.Reconnect the wire harness to the new thermostat and confirm the error stays cleared during a full test cycle.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Refrigerator Focused repair path: refrigerator door, airflow, sensor, defrost, dispenser, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux refrigerator repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux refrigerator model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. &tag=appliancefixg-20