Electrolux Dryer Error EHE

How to Fix EHE Error (Step-by-Step) Turn off the circuit breaker for the dryer and confirm the error stays cleared during a full test cycle.Remove the top panel of the dryer to get to the main control board.Take a picture of the wire connections to the board for reference.Disconnect all the wires from the old control board and confirm the error stays cleared during a full test cycle.Remove the screws that are holding the control board in place.Put the new main control board in and secure it with the screws.Reconnect all the wires according to the picture you took and reassemble the dryer.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dryer Focused repair path: dryer airflow, heating, motor, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dryer repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dryer model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. &tag=appliancefixg-20