How to Fix Electrolux dryer Error EH2

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: EH2 Difficulty: Easy

Problem: Supply voltage is too high.

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

no_parts

How to Fix EH2 Error (Step-by-Step)

Disconnect the dryer from the power outlet and confirm the error stays cleared during a full test cycle.
Verify that the dryer is plugged into the correct type of outlet (240V for electric dryers).
Do not use an extension cord, as this can affect the voltage supplied to the dryer.
If you are in an area with known voltage fluctuations, consider using a voltage stabilizer.
Turn the appliance off, wait about 2 minutes, then turn it back on.
Check for simple blockages (lint screen, drain path, or filter) and clean anything you find.
Make sure all doors, lids, and hoses are fully closed and seated correctly.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.