⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: EBE Difficulty: Hard
Problem: Console control problem.
How to Fix EBE Error (Step-by-Step)
- Disconnect the dryer from its power source by unplugging the power cord.
- Remove the top panel to get access to the control area. This usually involves removing a few screws from the back of the dryer.
- Locate the console control, also known as the user interface board. This is the board that your buttons and display are attached to.
- Take a picture of the ribbon cables and wire harnesses connected to the console control board.
- Carefully disconnect the wiring from the old board. Remove any screws or release clips holding it in place and remove it from the console.
- Install the new console control board, securing it properly. Reconnect the ribbon cables and wire harnesses as they were in your photo.
- Reassemble the dryer by reattaching the top panel. Plug the dryer in and check if the controls and display are now functioning correctly.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- 809160304
- 5304521373
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply