How to Fix Electrolux Dryer Error E86

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: E86 Difficulty: Easy

Problem: Incorrect selector setting signal.

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

no_parts

How to Fix E86 Error (Step-by-Step)

Turn the cycle selector knob to a different cycle setting than the one that was active when the error occurred.
Unplug the dryer from the power outlet, or switch off the corresponding circuit breaker.
Wait for at least 5-10 minutes to allow the internal electronics to fully reset.
Plug the dryer back in or turn the circuit breaker back on.
Select a new cycle and press ‘Start’ to see if the error has been resolved.
Turn the appliance off, wait about 2 minutes, then turn it back on.
Check for simple blockages (lint screen, drain path, or filter) and clean anything you find.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download

EPA Section 608 Certified Technician with 18+ years experience.

Browse all Electrolux error codes: Electrolux Error Codes