How to Fix Electrolux dryer Error E82

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: E82 Difficulty: Easy

Problem: User interface/button stuck/communication issue.

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

no_parts

How to Fix E82 Error (Step-by-Step)

Press and hold the ‘Cancel’ or ‘Power’ button for 5 seconds to attempt a reset.
If the error persists, unplug the dryer from the power outlet.
Wait for at least 5 minutes to allow the internal electronics to fully discharge.
Plug the dryer back into the power outlet and confirm the error stays cleared during a full test cycle.
Select a new cycle and press ‘Start’ to see if the error has cleared.
Gently wipe the control panel and around the buttons with a soft, dry cloth to remove any debris that may be causing a button to stick.
Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.