How to Fix Electrolux dryer Error E68

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: E68 Difficulty: Easy

Problem: FCV overcurrent protection.

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

no_parts

How to Fix E68 Error (Step-by-Step)

Unplug the dryer from the wall outlet and confirm the error stays cleared during a full test cycle.
Wait for at least 5 minutes to allow the electronic controls to fully reset.
Plug the dryer back into the wall outlet and confirm the error stays cleared during a full test cycle.
If the error persists, there may be an underlying issue with the control board that requires professional service.
Turn the appliance off, wait about 2 minutes, then turn it back on.
Check for simple blockages (lint screen, drain path, or filter) and clean anything you find.
Make sure all doors, lids, and hoses are fully closed and seated correctly.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.