Electrolux Dryer Error E67

How to Fix E67 Error (Step-by-Step) Disconnect the power to the dryer at the circuit breaker or by unplugging it.Access the heating sensor, which is typically located on the heater housing.Disconnect the wire harness from the sensor and confirm the error stays cleared during a full test cycle.Remove the old heating sensor, which may be held in by a screw or clip.Install the new heating sensor, ensuring it is securely in place.Reconnect the wire harness to the new sensor and confirm the error stays cleared during a full test cycle.Reassemble the dryer and restore power to test its functionality.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dryer Focused repair path: dryer airflow, heating, motor, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dryer repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dryer model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. &tag=appliancefixg-20