Electrolux Dryer Error E45

How to Fix E45 Error (Step-by-Step) Turn off the circuit breaker for the dryer and unplug it.Remove the top and front panels of the dryer to gain access to the door switch and main control board.Carefully examine the wiring harness connecting the door switch to the control board for any loose connections or damage.Test the door switch with a multimeter for proper operation. The switch should close the circuit when the door is shut.If the door switch is functioning correctly, the problem is likely with the main control board.Visually inspect the control board for any burn marks or damaged components.Replacing the main control board is a complex task and should be performed by a service service.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dryer Focused repair path: dryer airflow, heating, motor, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dryer repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dryer model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. &tag=appliancefixg-20Verified Compatible Alternatives:1349947001375388025304515407