⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: E32 Difficulty: Hard
Problem: Moisture sensor frequency is too low.
How to Fix E32 Error (Step-by-Step)
- Disconnect the dryer from the electrical outlet to prevent shock.
- Locate the moisture sensor bars (Part 134786110) inside the dryer drum. Inspect them for any foreign objects, such as a coin or paperclip, that could be shorting them out.
- Clean the sensor bars with rubbing alcohol and a clean cloth to remove any potential conductive residue.
- Access the back of the moisture sensor and inspect the wire harness (Part 5304515376). Ensure the wires are not pinched, frayed, or shorting against the dryer’s metal chassis.
- Disconnect the sensor harness from the main control board and test the sensor circuit for continuity. A continuous short indicates a problem with the wiring or sensors.
- If the sensors and wiring are in good condition, the problem points to a failure in the main control board (Part 134994700), which will need to be replaced.
- Carefully install the new control board, reconnect all harnesses, and reassemble the unit.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- 134786110
- 134994700
- 5304515376
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply