⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: E22 Difficulty: Hard
Problem: Condensate pump is defective or blocked.
How to Fix E22 Error (Step-by-Step)
- Turn off and unplug the dryer and confirm the error stays cleared during a full test cycle.
- Locate the condensate pump (Part 134523200). This is often found at the base of the unit.
- Inspect the pump and its connected hoses (Part 137249900) for any visible blockages or lint buildup.
- Disconnect the hoses from the pump and flush them with water to ensure they are clear.
- Check the pump’s impeller to see if it can move freely. If it is stuck or broken, the pump needs to be replaced.
- If the pump and hoses are clear, use a multimeter to test the pump motor for continuity. If there is no continuity, replace the pump.
- Reassemble all components and test the dryer and confirm the error stays cleared during a full test cycle.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- 137249900
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply