Electrolux Dryer Error E10

How to Fix E10 Error (Step-by-Step) Unplug the dryer from the wall outlet to ensure safety.Remove the top panel of the dryer by unscrewing the screws at the back or top edge.Locate the main electronic control board, which is typically a green circuit board housed in a plastic case.Carefully disconnect all wire harnesses connected to the board. It's helpful to take a photo beforehand for reference.Remove the screws or release the clips holding the old control board in place and remove it.Install the new control board (part number 137544800), securing it with the screws or clips.Reconnect all wire harnesses to the new board, referencing your photo to ensure correct placement, then reassemble the dryer.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dryer Focused repair path: dryer airflow, heating, motor, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dryer repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dryer model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. &tag=appliancefixg-20