Electrolux Dryer Error C8

How to Fix C8 Error (Step-by-Step) Ensure the dryer is unplugged from the power outlet and confirm the error stays cleared during a full test cycle.Locate the temperature sensor (thermistor). It is usually found on the blower housing or the heater duct at the rear of the dryer. You will likely need to remove the rear panel.Disconnect the two wires attached to the sensor. The connector can be pulled straight off.Remove the screw that holds the temperature sensor in place and remove the old sensor.Install the new temperature sensor and secure it with the screw.Reconnect the wire connector to the new sensor and confirm the error stays cleared during a full test cycle.Replace the rear panel, plug the dryer in, and test it by starting a new cycle.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dryer Focused repair path: dryer airflow, heating, motor, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dryer repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dryer model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. &tag=appliancefixg-20