Electrolux Dishwasher Error IH0

How to Fix IH0 Error (Step-by-Step) Cancel any running cycle and empty the dishwasher of all dishes.Clean the dishwasher filters thoroughly. Remove the lower spray arm and the filter assembly. Wash the filters under warm running water with a soft brush.Inspect the sump area at the bottom of the dishwasher (where the filter was) for any debris or suds and clean it out.Reinstall the clean filters and the lower spray arm correctly.Power cycle the dishwasher by turning it off at the circuit breaker for at least one minute before turning it back on. This can help reset the sensor's calibration.Start a new, empty wash cycle. The dishwasher will attempt to recalibrate the turbidity sensor at the beginning of the cycle. Allowing this cycle to complete without interruption can resolve the error.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dishwasher Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. Recommended Parts to Check No exact official OEM part number is listed here because the correct Electrolux dishwasher part can vary by complete model number. These are targeted part-category searches, not universal fit claims. Electrolux dishwasher drain pump Common replacement category: Drain pump Fit note: Exact OEM part number varies by complete Electrolux dishwasher model number. Confirm compatibility before buying. Why this category can matter: standing-water, drain, and incomplete-cycle symptoms after filter and hose checks. Search Amazon for Electrolux dishwasher drain pump Electrolux dishwasher water inlet valve Common replacement category: Water inlet valve Fit note: Exact OEM part number varies by complete Electrolux dishwasher model number. Confirm compatibility before buying. Why this category can matter: fill or low-water symptoms after supply and float checks. Search Amazon for Electrolux dishwasher water inlet valve Electrolux dishwasher control board Common replacement category: Electronic control board Fit note: Exact OEM part number varies by complete Electrolux dishwasher model number. Confirm compatibility before buying. Why this category can matter: repeating control faults after latch, wiring, and power checks. Search Amazon for Electrolux dishwasher control board Before ordering: match the part to the complete Electrolux dishwasher model number on the appliance tag.