Skip to main content
Appliance Fix Guide

Electrolux Dishwasher error code

Electrolux Dishwasher Error IF1

High water level / Diverter valve fault.

High water level / Diverter valve fault.

HardStart with 5-15 minutes of safe checks
✅ WORTH FIXINGParts under $100
Electrolux dishwasher repair guide for error IF1
Error codeIF1Dishwasher

Start here before buying a part or taking the appliance apart.

  1. 1
    Shut off the power to your dishwasher from

    Shut off the power to your dishwasher from your home's circuit breaker.

  2. 2
    You will need to pull the dishwasher out

    You will need to pull the dishwasher out from under the counter to access the diverter valve and circulation pump.

  3. 3
    After pulling the unit out, carefully tilt it

    After pulling the unit out, carefully tilt it on its back to get to the components underneath. Place a towel down to protect your floor.

A quick explanation

What does IF1 mean?

High water level / Diverter valve fault.

The answer you came for

How to fix Electrolux dishwasher error IF1

Start with the safest checks and work from simple to technical.

  1. 1

    Shut off the power to your dishwasher from

    Shut off the power to your dishwasher from your home's circuit breaker.

  2. 2

    You will need to pull the dishwasher out

    You will need to pull the dishwasher out from under the counter to access the diverter valve and circulation pump.

  3. 3

    After pulling the unit out, carefully tilt it

    After pulling the unit out, carefully tilt it on its back to get to the components underneath. Place a towel down to protect your floor.

  4. 4

    Locate the diverter valve (part A00056504) and the

    Locate the diverter valve (part A00056504) and the circulation pump (part 154844001). Inspect them for any visible signs of damage or blockage.

  5. 5

    To replace the diverter valve, disconnect the attached

    To replace the diverter valve, disconnect the attached hoses and electrical connector, then remove the screws holding it in place. Install the new valve and reconnect everything.

  6. 6

    For the circulation pump, disconnect its hoses and

    For the circulation pump, disconnect its hoses and wiring, then unbolt it from the sump. Install the new pump, ensuring all connections are tight.

  7. 7

    Carefully set the dishwasher upright, slide it back

    Carefully set the dishwasher upright, slide it back into place, and restore power to test its function.

  8. 8

    Turn the appliance off, wait about 2 minutes,

    Turn the appliance off, wait about 2 minutes, then turn it back on.

Read the additional checks from the current guide

How to Fix IF1 Error (Step-by-Step) Shut off the power to your dishwasher from your home's circuit breaker.You will need to pull the dishwasher out from under the counter to access the diverter valve and circulation pump.After pulling the unit out, carefully tilt it on its back to get to the components underneath. Place a towel down to protect your floor.Locate the diverter valve (part A00056504) and the circulation pump (part 154844001). Inspect them for any visible signs of damage or blockage.To replace the diverter valve, disconnect the attached hoses and electrical connector, then remove the screws holding it in place. Install the new valve and reconnect everything.For the circulation pump, disconnect its hoses and wiring, then unbolt it from the sump. Install the new pump, ensuring all connections are tight.Carefully set the dishwasher upright, slide it back into place, and restore power to test its function.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dishwasher Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. Verified Compatible Alternatives:A00056504

If the code comes back

Do not keep replacing parts based only on the code. Repeat the safe checks above. If the fault remains, stop and arrange qualified service rather than ordering from the code alone.

Recommended part

Recommended part for this error code

Part listed in the current guide

OEM candidate: 154844001

Price noted in the current guide: $62-$91

Why this part is shown: It is associated with Electrolux Dishwasher error IF1 in the current guide. The error code alone does not prove this part has failed.

Compatibility varies by model. Confirm that the Amazon listing includes your complete dishwasher model number before ordering.

Amazon part link View recommended part on Amazon

You can open the recommendation now. Check model compatibility on the Amazon page before purchasing.

Affiliate disclosure: qualifying purchases may earn this site a commission at no additional cost to you.

Replacement options

Ready to replace your dishwasher?

If repairing this dishwasher no longer feels worthwhile, compare three replacement paths below.

Why shop your replacement on Amazon?

  • Fast, free delivery

    Prime members can get fast, free delivery on eligible items.

  • Convenient delivery options

    Select large appliances may offer scheduled or Room of Choice delivery.

  • Haul-away options

    Haul-away may be available for select appliances and delivery areas.

  • Installation help

    Installation or assembly may be available on select items.

Delivery and service options, fees, and availability vary by item, seller, and delivery ZIP code. Confirm available services at Amazon checkout.

Affiliate disclosure: qualifying purchases may earn this site a commission at no additional cost to you.

Make the money decision

Repair or replace calculator

Use the age and total repair estimate to get a simple comparison. This is guidance, not a guarantee.