How to Fix Electrolux Dishwasher Error IF0

Error Code: IF0 Difficulty: Hard

Problem: The water level inside the appliance is too high.

How to Fix IF0 Error (Step-by-Step)

1. Disconnect the dishwasher from power and water. Turn off the circuit breaker for the dishwasher and shut off the water supply valve, usually located under the sink.
2. Remove the bottom front panel of the dishwasher to access the internal components. You may need a screwdriver or nut driver for this.
3. Locate the water inlet valve, which is typically near where the water supply line connects to the dishwasher. Inspect it for any visible signs of damage or leaks.
4. Check the float switch, a small plastic dome or cylinder in the bottom of the dishwasher tub. Ensure it moves freely up and down and is not stuck in the down position.
5. Inspect the drain pump and hose for any clogs or obstructions that might prevent water from draining properly. Clear any debris you find.
6. If the water inlet valve, float switch, or drain pump appear faulty, they will need to be replaced. This is a complex job that may require a professional.
7. After performing these checks and any necessary replacements, reconnect the power and water supply and run a test cycle to ensure the error is resolved.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Electrolux error codes: Electrolux Error Codes