How to Fix Electrolux Dishwasher Error IF0, EF0

Error Code: IF0, EF0 Difficulty: Hard

Problem: Water replenishment timeout or overfilling issue.

How to Fix IF0, EF0 Error (Step-by-Step)

1. Turn off the power to the dishwasher at the circuit breaker and shut off the water supply under the sink.
2. Remove the lower access panel of the dishwasher to get to the main components.
3. Find the water inlet valve, which connects to the main water line. Check for any visible leaks or damage to the valve and its connections.
4. Locate the float switch in the bottom of the dishwasher tub. Make sure it can move up and down without sticking. A stuck float can cause filling issues.
5. Carefully inspect the wiring to both the water inlet valve and the float switch for any loose or damaged connections.
6. If either the water inlet valve or the float switch is determined to be faulty, it should be replaced. This is often a task best left to a qualified service.
7. Once the parts are inspected and replaced if necessary, reassemble the dishwasher, turn the power and water back on, and run a cycle to check if the error is cleared.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Electrolux error codes: Electrolux Error Codes