Electrolux Dishwasher Error I43

How to Fix I43 Error (Step-by-Step) Begin by completely disconnecting the dishwasher from its power source at the circuit breaker and turning off the water supply.Pull the dishwasher out from under the counter to access the side and bottom components.Identify the pressure sensor, which is a small part connected to the dishwasher's sump housing.Disconnect the wiring harness attached to the sensor. Then, carefully remove the hose connected to it, being prepared for a small amount of water to spill.Attach the hose to the new pressure sensor and reconnect the wiring harness. Make sure both are securely fastened.Slide the dishwasher back into place, reconnect the power and water, and run a check cycle to confirm the repair.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dishwasher Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. Verified Compatible Alternatives:5304504077