⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: I20, E20, 2 FLASHES Difficulty: Moderate
Problem: Draining issue. The dishwasher is not draining water properly.
How to Fix I20, E20, 2 FLASHES Error (Step-by-Step)
- Disconnect the dishwasher from the power supply and confirm the error stays cleared during a full test cycle.
- Pull out the lower dish rack to get to the sump area.
- Remove the filter system by twisting it counter-clockwise and lifting it out. Clean all parts of the filter.
- Check the sump area for any debris or foreign objects and remove them.
- Inspect the drain hose for any clogs or sharp bends. Disconnect it if necessary to clear any obstructions.
- Examine the drain pump for any blockages. You may need to remove it to inspect the impeller.
- After cleaning and clearing any blockages, reassemble everything and run a drain cycle to check for proper function.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- A00044305
- A00126401
- 5304524920
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply