Electrolux Dishwasher Error ER-01

How to Fix ER-01 Error (Step-by-Step) Turn the appliance off to the dishwasher at the circuit breaker. Remove the lower access panel at the front of the dishwasher by unscrewing the retaining screws. Place a towel on the floor and look inside for the leak sensor, which is a small switch with a float, located in the base pan. Check the base pan for any standing water that may have triggered the sensor. If water is present, find and repair the source of the leak (e.g., loose hose, cracked pump, or bad door seal) before proceeding. Disconnect the wire harness from the old leak sensor and remove it from its mounting clip. Install the new sensor, reconnect the wiring, and reattach the lower access panel. Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dishwasher Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. Recommended Parts to Check No exact official OEM part number is listed here because the correct Electrolux dishwasher part can vary by complete model number. These are targeted part-category searches, not universal fit claims. Electrolux dishwasher drain pump Common replacement category: Drain pump Fit note: Exact OEM part number varies by complete Electrolux dishwasher model number. Confirm compatibility before buying. Why this category can matter: standing-water, drain, and incomplete-cycle symptoms after filter and hose checks. Search Amazon for Electrolux dishwasher drain pump Electrolux dishwasher water inlet valve Common replacement category: Water inlet valve Fit note: Exact OEM part number varies by complete Electrolux dishwasher model number. Confirm compatibility before buying. Why this category can matter: fill or low-water symptoms after supply and float checks. Search Amazon for Electrolux dishwasher water inlet valve Electrolux dishwasher control board Common replacement category: Electronic control board Fit note: Exact OEM part number varies by complete Electrolux dishwasher model number. Confirm compatibility before buying. Why this category can matter: repeating control faults after latch, wiring, and power checks. Search Amazon for Electrolux dishwasher control board Before ordering: match the part to the complete Electrolux dishwasher model number on the appliance tag. Repair-Or-Replace Cost Calculator Use this calculator when the Electrolux dishwasher still fails after the basic checks. Compare the estimated repair cost, appliance age, and replacement price before ordering parts. Still Not Working? If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure. Browse all Electrolux error codes: Electrolux Error Codes