Electrolux Dishwasher Error E01

How to Fix E01 Error (Step-by-Step) Turn off the power to the dishwasher at the circuit breaker.Pull the dishwasher out from under the counter to access the base.Locate the leak sensor (float switch) in the base pan.Inspect the base pan for any visible water and dry it thoroughly.Disconnect the wires from the leak sensor and remove it.Install the new leak sensor and reconnect the wiring and confirm the error stays cleared during a full test cycle.Check all hoses and connections for leaks before sliding the dishwasher back into place.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dishwasher Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. Verified Compatible Alternatives:1548255017154655901