Electrolux Dishwasher Error C2

How to Fix C2 Error (Step-by-Step) Turn off the dishwasher's power at the circuit breaker and confirm the error stays cleared during a full test cycle.Open the dishwasher door and remove the bottom dish rack.Locate and remove the filter assembly at the bottom of the tub by twisting it loose. Clean it thoroughly under running water.Inspect the sump area below the filter for any food particles or debris and clean it out.Check the drain hose for any clogs or kinks that could prevent proper draining.On professional models, this can also indicate a high boiler temperature, which requires inspection of the temperature sensor and heating element by a qualified service.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dishwasher Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. Verified Compatible Alternatives:11131600045304483441