Error Code: FOAM DETECTION SYMBOL Difficulty: Easy
Problem: Too much foam has been detected during the wash cycle.
How to Fix FOAM DETECTION SYMBOL Error (Step-by-Step)
- Pause the current wash cycle. If the machine will not pause, turn it off.
- Wait for 15-20 minutes to allow the foam to dissipate on its own.
- Once the foam has reduced, select a ‘Rinse’ or ‘Spin’ cycle and run it without adding any more detergent. This will help to flush out the excess suds.
- If there is still a lot of foam, you may need to run an additional rinse cycle.
- To prevent this in the future, reduce the amount of detergent you are using, especially for smaller or lightly soiled loads.
- Ensure you are using a high-efficiency (HE) detergent, as these are formulated to produce fewer suds.
- If you have soft water, you will need to use significantly less detergent than the manufacturer’s recommendation.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply