⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: F67 Difficulty: Hard
Problem: Card error.
How to Fix F67 Error (Step-by-Step)
- Disconnect the washer from its power source by unplugging it from the wall outlet.
- Remove the top panel of the washer to gain access to the internal components. This usually involves removing a few screws from the back.
- Identify the main control board. It is often located in a protective plastic housing.
- Before disconnecting any wires, take a clear picture to remember their placement. Proceed to disconnect all electrical connectors from the control board.
- Unfasten the screws or clips that hold the control board in its housing and carefully take out the old board.
- Place the new control board into the housing and secure it with the screws or clips. Reconnect all the wires as they were originally.
- Put the top panel back on and secure it. Plug the washer back in and start a cycle to confirm that the card error is gone.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Bosch model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Get the Washer Error Code Guide: https://appliancewhisperer.gumroad.com/l/sirmci
Leave a Reply