⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: E44 Difficulty: Hard
Problem: Dryer Motor Control Error.
How to Fix E44 Error (Step-by-Step)
- Turn off the circuit breaker for the dryer and unplug it from the wall.
- Remove the top or back panel of the dryer to locate the main electronic control board.
- Take a clear photo of the wire connections on the board before you disconnect anything.
- Carefully unplug all the wire harnesses connected to the old motor control board.
- Remove the screws or release the clips holding the control board in its housing.
- Install the new control board (part 00499976 or 481590), securing it properly and reconnecting all wire harnesses based on your photo.
- Reattach the dryer panels, restore power, and run a cycle to confirm the fix.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Parts Availability Note: For this Electrolux/Frigidaire error code, exact OEM part numbers can vary by model revision and serial range. We’ve listed the most likely component(s), but confirm compatibility using your full model number before ordering. If no exact SKU is shown, use this guide for diagnosis first, then verify the matching OEM part on RepairClinic or PartSelect.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Bosch model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Bosch error codes: Bosch Error Codes
Leave a Reply