Bosch Dishwasher Error E0105

How to Fix E0105 Error (Step-by-Step) Disconnect the dishwasher from power by turning off the circuit breaker and unplugging the unit. Shut off the water supply valve, typically located under the sink.Carefully slide the dishwasher out from under the counter. You may need to remove mounting screws securing it to the countertop or cabinets.Lay the dishwasher on its back on a towel or blanket to access the base. Remove the base cover panel to expose the internal components.Locate the Zeolite container, which houses the heater. Disconnect the wiring harness attached to it and any connected hoses. Release the clips or screws holding it in place and remove the old container.Install the new Zeolite heater and container assembly, ensuring all connections are secure. Reconnect the wiring harness and hoses.Locate the main power module (control board). Carefully label and disconnect all wire connectors. Remove the screws securing the module and replace it with the new one, reconnecting all wires to their correct terminals.Reassemble the dishwasher by reattaching the base panel, sliding it back into place, securing it, and reconnecting the power and water supply. Run a test cycle to confirm the repair.Turn the appliance off, wait about 2 minutes, then turn it back on. Parts Availability Note: For this Electrolux/Frigidaire error code, exact OEM part numbers can vary by model revision and serial range. We’ve listed the most likely component(s), but confirm compatibility using your full model number before ordering. If no exact SKU is shown, use this guide for diagnosis first, then verify the matching OEM part on RepairClinic or PartSelect. Recommended Parts to Check No exact official OEM part number is listed here because the correct Bosch dishwasher part can vary by complete model number. These are targeted part-category searches, not universal fit claims. Bosch dishwasher water inlet valve Common replacement category: Water inlet valve Fit note: Exact OEM part number varies by full Bosch dishwasher model number. Confirm compatibility before buying. Confidence: MediumThis category can be relevant for fill and water-supply faults after the tap, hose, and inlet screen are checked. Search Amazon for Bosch dishwasher water inlet valve Bosch dishwasher drain pump Common replacement category: Drain pump Fit note: Exact OEM part number varies by full Bosch dishwasher model number. Confirm compatibility before buying. Confidence: MediumThis category can be relevant for drain and standing-water symptoms after the filter, sump, and hose are checked. Search Amazon for Bosch dishwasher drain pump Bosch dishwasher circulation pump Common replacement category: Circulation pump / wash motor Fit note: Exact OEM part number varies by full Bosch dishwasher model number. Confirm compatibility before buying. Confidence: MediumThis category can be relevant for wash, spray-arm, and circulation symptoms after filters and spray arms are checked. Search Amazon for Bosch dishwasher circulation pump Before ordering: match the part to the complete Bosch dishwasher model number on the appliance tag.

What to Check Next on This Bosch Dishwasher Bosch dishwasher symptom: Use the symbol or code as a starting point, then match the repair path to what the dishwasher is actually doing. Confirm whether the display is a normal cycle/status symbol or a recurring fault that stops operation. Check water supply, filter, sump, spray arms, drain path, and door latch before replacing electronic parts. If the same problem returns after basic checks, inspect the matching sensor, pump, heater, wiring, or control path based on the symptom. If the symptom returns after these checks, use the full Bosch model number from the door tag before ordering any part. The same display message can point to different parts depending on the exact model and what the dishwasher does during fill, wash, drain, or dry. Still Not Working? If the replacement part didn't fix the issue, you may have a wiring problem or main board failure.