Error Code: OFB Difficulty: Hard
Problem: The washer load is out of balance.
How to Fix OFB Error (Step-by-Step)
- Unplug the washer and disconnect the water hoses and confirm the error stays cleared during a full test cycle.
- Open the washer lid and remove the washplate cap to access the central bolt.
- Unscrew the bolt and lift the washplate (Part W10780045) out of the tub.
- Underneath the washplate, locate and remove the drive hub kit (Part W10821956).
- Prop the washer up to access the bottom and replace the bearing kit (Part W11130362).
- At the same time, replace all four suspension rods (Part W10780048) located at each corner of the tub.
- Reassemble the washer by following these steps in reverse, then run a test cycle.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Verified Compatible Alternatives:
- W10780048
- W10821956
- W11130362
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Amana error codes: Amana Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply