⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: ND Difficulty: Moderate
Problem: No drain. This is typically a drain pump problem or can be caused by excess suds.
How to Fix ND Error (Step-by-Step)
- Unplug the washer from the power outlet for safety and confirm the error stays cleared during a full test cycle.
- Turn off the water supply and disconnect the drain hose from the wall drain.
- Place a bucket or pan under the drain pump to catch any residual water.
- Locate the drain pump at the bottom of the washer and disconnect the hoses attached to it.
- Remove the screws holding the drain pump (Part W10876600) in place and remove the old pump.
- Install the new drain pump and reconnect the hoses and mounting screws.
- Reconnect the main drain hose (Part WPW10730972) to the wall, plug in the washer, and run a drain/spin cycle to test.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- WPW10730972
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply