⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: F0E8 Difficulty: Moderate
Problem: Too much residual water has been detected in the washer.
How to Fix F0E8 Error (Step-by-Step)
- Unplug the washer from its power source and turn off the water supply valves.
- Place towels on the floor and carefully tilt the washer forward, resting it against a wall for stability to access the bottom.
- Locate the drain pump, which is a small component with two large hoses attached.
- Put a shallow pan underneath the hoses to catch water. Use pliers to squeeze the clamps on the hoses and slide them off the pump ports.
- Disconnect the electrical wire connector from the pump and confirm the error stays cleared during a full test cycle.
- Remove the mounting screws that hold the old pump in place and take it out.
- Install the new pump, secure it with the screws, and reattach the hoses, clamps, and electrical connector before carefully returning the washer to its upright position.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
OEM Part #: Drain Pump: WPW10730972, W10730972, W10130913, 8540024
Estimated Market Price: $45-$115
Check Price & Availability → Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply