Amana Refrigerator Error EF

How to Fix EF Error (Step-by-Step) Disconnect the refrigerator from the power outlet and confirm the error stays cleared during a full test cycle.Empty the freezer compartment and remove the freezer shelves and confirm the error stays cleared during a full test cycle.Remove the back panel inside the freezer to access the evaporator fan motor.Disconnect the wire harness connected to the fan motor and confirm the error stays cleared during a full test cycle.Remove the screws that mount the fan motor to the freezer wall.Install the new evaporator fan motor (Part Number: WPW10156818 or W10861521) and reconnect the wiring.Reinstall the back panel, shelves, and plug the refrigerator back in.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Refrigerator Focused repair path: refrigerator door, airflow, thermistor, defrost, fan, compressor start, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Confirm the doors seal, the interior lights shut off, and vents are not blocked before replacing sensors or boards. Look for frost pattern clues, stalled fans, warm compartments, water or ice symptoms, and recent power interruptions. For temperature faults, inspect the evaporator fan, thermistor, defrost path, damper, condenser airflow, and board connectors. Use the complete Amana refrigerator model number before ordering sensors, fans, boards, dampers, valves, or start components. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. Verified Compatible Alternatives:WPW10156818