Amana Refrigerator Error E44

How to Fix E44 Error (Step-by-Step) Disconnect the refrigerator from its power source and confirm the error stays cleared during a full test cycle.Remove all shelves, drawers, and food from the fresh food compartment.Locate and remove the screws holding the panel at the back of the compartment. This panel covers the evaporator fan.Gently pull the panel away and disconnect any attached wiring to set it aside.Identify the fresh food evaporator fan motor. Unplug its wire harness.Remove the mounting screws holding the fan motor in place and take it out. You may need to transfer the fan blade to the new motor.Install the new motor, reconnect the wiring, and reassemble the compartment panels and shelves before plugging the unit back in.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Refrigerator Focused repair path: refrigerator door, airflow, thermistor, defrost, fan, compressor start, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Confirm the doors seal, the interior lights shut off, and vents are not blocked before replacing sensors or boards. Look for frost pattern clues, stalled fans, warm compartments, water or ice symptoms, and recent power interruptions. For temperature faults, inspect the evaporator fan, thermistor, defrost path, damper, condenser airflow, and board connectors. Use the complete Amana refrigerator model number before ordering sensors, fans, boards, dampers, valves, or start components. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. &tag=appliancefixg-20