Amana Refrigerator Error E14

How to Fix E14 Error (Step-by-Step) Unplug the refrigerator from the power source and confirm the error stays cleared during a full test cycle.Empty the fresh food compartment of all shelves and food items to get clear access.Locate the temperature sensor (thermistor). It is usually found along the back or side wall, often behind a small plastic cover.Remove the cover, which may require a screwdriver or simply unsnapping it.Disconnect the wire harness from the old sensor and confirm the error stays cleared during a full test cycle.Remove the old sensor from its mounting clip and install the new one.Reconnect the wire harness, replace the cover, reinstall the shelves, and plug the refrigerator back in.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Refrigerator Focused repair path: refrigerator door, airflow, thermistor, defrost, fan, compressor start, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Confirm the doors seal, the interior lights shut off, and vents are not blocked before replacing sensors or boards. Look for frost pattern clues, stalled fans, warm compartments, water or ice symptoms, and recent power interruptions. For temperature faults, inspect the evaporator fan, thermistor, defrost path, damper, condenser airflow, and board connectors. Use the complete Amana refrigerator model number before ordering sensors, fans, boards, dampers, valves, or start components. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. &tag=appliancefixg-20