Error Code: D8 AND D9 ILLUMINATED Difficulty: Hard
Problem: Refrigerator and defrost sensor issue.
How to Fix D8 AND D9 ILLUMINATED Error (Step-by-Step)
- Disconnect the refrigerator from its power source to prevent electrical shock.
- First, replace the refrigerator sensor (thermistor) located in the fresh food section by following the steps for the ‘D8’ error code.
- Next, empty the freezer compartment and remove the screws holding the interior back panel.
- Carefully detach the panel to expose the evaporator coils. The defrost sensor is a small component clipped directly onto the evaporator tubing.
- Unplug the wire connector for the old defrost sensor and remove it from the clip.
- Install the new defrost sensor by clipping it onto the tubing and reconnecting the wire harness.
- Reinstall the freezer’s back panel, restore power to the unit, and monitor for normal operation.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Amana Refrigerator
Focused repair path: refrigerator door, airflow, thermistor, defrost, fan, compressor start, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.
- Confirm the doors seal, the interior lights shut off, and vents are not blocked before replacing sensors or boards.
- Look for frost pattern clues, stalled fans, warm compartments, water or ice symptoms, and recent power interruptions.
- For temperature faults, inspect the evaporator fan, thermistor, defrost path, damper, condenser airflow, and board connectors.
- Use the complete Amana refrigerator model number before ordering sensors, fans, boards, dampers, valves, or start components.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.
Recommended Replacement Part
- Refrigerator Sensor (Thermistor)
When It’s Better to Replace Than Repair
Refrigerator repairs can become costly when sealed-system, control, defrost, fan, or ice-maker issues repeat.
Confirm width, height, depth, door swing, counter-depth needs, water line, and delivery path before ordering.
For repair parts, verify exact fit with the full refrigerator model number before buying; these links are general replacement-appliance shopping options.
- [OK]Water inlet valve, ice maker, or fan failures keep returning
- [OK]Defrost heater, thermostat, or sensor faults stack up
- [OK]Compressor or sealed-system repair is not economical
- [OK]Food-loss risk is becoming a pattern
Recommended Refrigerator Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply